Towertalk
[Top] [All Lists]

[TowerTalk] Fw: Cable pulling

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Fw: Cable pulling
From: Bob Gibson <w5rg@yahoo.com>
Reply-to: Bob Gibson <w5rg@yahoo.com>
Date: Sun, 6 May 2012 15:47:22 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
How long are the sections? Why not just lay the sections out and run the 
cables into each section one at a time..that's what I did for 350ft run..Bob 
Bob Gibson W5RG

----- Forwarded Message -----
From: David Aslin <david@aslinvc.com>
To: towertalk@contesting.com 
Sent: Sunday, May 6, 2012 4:48 PM
Subject: [TowerTalk] Cable pulling

Gerald's note prompts me to ask a related question:
What techniques are folks using for the first pull through a conduit?
Background: Like Gerald, I plan to have a 400ft+ run of 4 inch
corrugated irrigation tubing.  A 400ft fish tape would be hard to
find/expensive, but I need to get a pull rope through the conduit before
I can do the first cable pull (LDF5-50)  How?

73
David G3WGN  WJ6O

------------------------------
Date: Sun, 6 May 2012 15:13:42 -0300
From: "VE1DT-Towertalk" <gboutin@seaside.ns.ca>
Subject: [TowerTalk] Wire Soap - How Much?
To: <towertalk@contesting.com>
Message-ID: <001801cd2bb3$f96e2ce0$ec4a86a0$@seaside.ns.ca>
Content-Type: text/plain;    charset="us-ascii"

I've no experience in running cables through conduit, but I do know that
I want to use a cable lube. I can get Klein #15028 1 quart bottles
locally, but I don't know how much I will need. Also, I know I don't
want to run out part way. In browsing through the archives, the answer I
keep seeing is "lots".

In my case, I am using 4" diameter corrugated irrigation tubing for a
couple of LMR600 cables, a couple rotator cables and a few CAT5 cables.
Total
length is 400 feet. Worst case would be the volume of the conduit.
Using
the formula,    pi *r^2 *length    tells me about 30 gallons. I am not
planning on doing that.

Polywater  http://www.youtube.com/watch?v=kr87VQcJeK8 ; says to use this
formula for PolywaterJ: Gallons = 0.0015 * Diameter(inches) *
Length(feet).
This comes out to 2.4 gallons. Using 1 quart bottles, this comes to
about
$150 here. Grainger also sells larger 1 gallon containers of 3M WL lube
at about the same price as two of the Klein one quart squeeze bottles.

Does 3 gallons sound about right?

--
Gerald Boutin, VE1DT

********************************
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>