Tnx for the replies. Guess I didn't dig quite deep enough on the web
page for the tool.
Phil
N9LAH
On 5/25/2012 8:21 PM, Phil Snyder wrote:
> Does anyone know if this tool, the DXE-UT-8213 designed to prep RG-8
> LMR-400 etc. will work on RG-11? I am thinking not as I thought part of
> the 50/75 ohm characteristic came from the spacing of the shield from
> the center ( I may also be completely wrong on that point). I could be
> all wet on this one as well but figured this might be the place to find
> the right answer, flame or not.
>
> Phil
>
> N9LAH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2012.0.2176 / Virus Database: 2425/5022 - Release Date: 05/25/12
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|