Towertalk
[Top] [All Lists]

Re: [TowerTalk] Ameriton RCS4 and N Connectors

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Ameriton RCS4 and N Connectors
From: K8RI <K8RI-on-TowerTalk@tm.net>
Date: Sat, 07 Jul 2012 23:41:49 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 7/7/2012 10:26 PM, Charlie Gallo wrote:
> Hi Gang,
> NOT critical, but has anyone changed a RCS-4 over to N connectors?  I've read 
> all the pros/cons of N connectors here, but I've pretty much have decided 
> that where I can/as I can, I'm replacing al my PL/SO-259s with N connectors, 
> and was wondering is anyone converted this unit
>

Yes,although I did the RCS-8) but I will eventually convert it back. 
The conversion is very simple All you do is physically replace the one 
type with the other using the chassis connector that uses one screw (or 
rivet) in each corner. I used solder wick to remove the connecto joint 
at the PC board. I suppose you could also use the chassis connector that 
is threaded, but I'd still prefer the one using 4 small screws.

As I said, after doing the conversion (the original connectors needed 
replacing anyway), I will eventually be going back to UHF connectors. 
I've blown out too many N connectors due to high voltage caused by SWR 
and nearby lightning strikes.


> BTW - the Reason?  Last year, I had "issues" with my 80m antenna on Field Day 
> (I run from home - class 1E), and

I THOUGHT I had it fixed.  I don't run a lot of 80m (It is a short 
antenna, low, but it is the best I can do on my city lot).

Anyway, This year, it failed again, but the GOOD news was it didn't go 
intermittent, it failed hard.

  The failure was at the junction from the Buryflex to the lighter coax 
going up in the air to my 80m dipole

(600w max on the traps, so...).  The AMP brand UHF barrel connector had 
failed -

the spring fingers that grip the center conductor had become extremely 
loose on one side - non conducting!

I decided that at least in that connector, I wanted to put in a female 
and male pair, and get rid of the barrel,

and the best way to do that was with N connectors (I did think about 
7-16 din, but)

They make UHF connectors like that. You put a male on one and female on 
the other.  Gets rid on one connector.


BTW, please set you posting line length. Each paragraph comes through as 
a single line.

73

Roger (K8RI)

>



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>