Towertalk
[Top] [All Lists]

Re: [TowerTalk] Thrust bearing problem

To: w6rgs@cox.net, "Tower and HF antenna construction topics." <towertalk@contesting.com>
Subject: Re: [TowerTalk] Thrust bearing problem
From: Jeff Goldman <k3dua@erols.com>
Date: Mon, 16 Jul 2012 15:36:22 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Sorry, the link didn't transfer.  I'll try again.

http://www.surpluscenter.com/sort.asp?keyword=PBF4&catname=powerTrans&PAGELEN=20&PageNo=3

73,
Jeff, k3dua



On Jul 16, 2012, at 3:34 PM, Jeff Goldman wrote:

> Bill,
> 
> Take the whole thing and put it in a heavy vise.   Then cut off the remaining 
> lower 2 feet of the mast, leaving only about 2-3 inches of the mast stuck in 
> the bearing.   Get a hacksaw, and put the blade through the center of the 
> mast and cut the mast from the inside out to the bearing.   Make =a total of 
> 4 cuts at 90 degrees apart, and the segments should then be easier to remove 
> (it still take a heavy hammer, but now there is some room for the segments to 
> break loose from the bearing.   
> 
> If that doesn't work, here is a link to Surplus Centerand they sell bearings.
> Surplus Center
> They have four 2 inch bearings, 2 with set-screws, and 2 with locking 
> collars.  One of these should fit your needs.
> 
> No association with the Surplus Center, just a happy customer.
> 
> 73,
> Jeff, k3dua
> 
> 
> 
> On Jul 16, 2012, at 3:07 PM, w6rgs@cox.net wrote:
> 
>> Hello group,
>> I purchased a used Tri-Ex W-51 tower.  The 4-bolt thrust bearing was 
>> very rusty and had the 2"-diameter steel mast rusted to the 
>> bearing.  The upper part of the mast had been cut from the bearing, 
>> so removing the bearing and the 2' lower part of the mast as a unit was easy.
>> I've tried lots of penetrating oil over a 3-month period, big pipe 
>> wrenches and a vise, but I'm still unable to free the mast stub from 
>> the bearing.  I was hoping to refurbish the thrust bearing for 
>> re-use, but no luck.
>> Also, no luck searching around for a replacement bearing unit that 
>> meets the same bolt-hole dimensions.   Found a place called Hub City, 
>> but the measurements are off.  Anyone know of another source for a 
>> 4-bolt thrust bearing?  Already tried Tashjian Towers.
>> Thanks in advance.
>> 
>> 73  Bill W6RGS
>> 
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>