Towertalk
[Top] [All Lists]

Re: [TowerTalk] troubleshooting help: non-turning G-1000DXA rotor

To: "'Barry N1EU'" <n1eu.barry@gmail.com>, "'Tower Talk List'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] troubleshooting help: non-turning G-1000DXA rotor
From: "Mike" <noddy1211@sbcglobal.net>
Date: Sun, 2 Sep 2012 10:25:22 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I have a motor out of 2 year old G-1000DX and it says DC 24 volts.

Mike

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Barry
N1EU
Sent: Sunday, September 02, 2012 6:19 AM
To: Tower Talk List
Subject: [TowerTalk] troubleshooting help: non-turning G-1000DXA rotor

I'd appreciate any troubleshooting tips for a suddenly non-turning G-1000DXA
rotor.  Cable continuity checks good, reading 500 ohms across the pot and 64
ohms across the motor back at the controller connector.  If I hang a
voltmeter across the motor pins (4,5) on the back of the controller with
cable disconnected, I don't see any voltage generated by the controller when
I press the LEFT/RIGHT turn buttons.  Shouldn't I be seeing DC Voltage?  If
so, do I next check the fuse on the PS-Unit PCB or ???

Any advice appreciated.

Tnx/73,
Barry N1EU
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2197 / Virus Database: 2437/5242 - Release Date: 09/02/12

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>