On 11/16/2012 9:46 PM, Jim Brown wrote:
On 11/16/2012 6:04 PM, john@kk9a.com wrote:
Once I had a defective one
where the threads inside the shell were not deep enough and
unfortunately I
didn't notice this until after it was soldered and there was already a
connector on the other end.
I've had two of these, out of perhaps a hundred or so connectors.
2% failure rate?
I had one that had no threads and didn't discover it until I tried to
screw it onto the other connector. I just cut it off, pitched it and
installed another.
73
Roger (K8RI)
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|