I used these successfully in Minnesota on 64 radials (beats the
"sodbusting" of burying radials by miles). Used the DX engineering "plate"
as a connector.
I got my staples at Menards. My mower only manged to "chew up" about four
of the radials over maybe four or five years.
Results were excellent for my HF2V.
Larry Wo0Z
On Fri, Feb 8, 2013 at 8:59 AM, Pete Smith N4ZR <n4zr@contesting.com> wrote:
> Anyone else used bobby pins?
>
> 73, Pete N4ZR
> Check out the Reverse Beacon Network at
> http://reversebeacon.net,
> blog at reversebeacon.blogspot.com.
> For spots, please go to your favorite
> ARC V6 or VE7CC DX cluster node.
>
>
> On 2/8/2013 7:42 AM, Phil Snyder wrote:
>
>> I don't remember if it was here or one of my other antenna lists. Someone
>> was looking for Ross Radial staples. I just noticed they have been listed
>> again on EBay, so if this was the place I saw it they are available again.
>>
>> Phil
>> N9LAH
>> ______________________________**_________________
>>
>>
>>
>> ______________________________**_________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/**mailman/listinfo/towertalk<http://lists.contesting.com/mailman/listinfo/towertalk>
>>
>>
> ______________________________**_________________
>
>
>
> ______________________________**_________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/**mailman/listinfo/towertalk<http://lists.contesting.com/mailman/listinfo/towertalk>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|