According to Skip KJ6Y, the pulley's are custom made for UST. The
bearing in the middle is OTS, but there is a rather involved
procedure to press it in without wrecking it, then you have
to make a series of dents in it to secure it in place.
Have you tried lubricating it to see if you can bring it back?
Rick N6RK
On 3/10/2013 5:19 PM, Rich Hallman - N7TR wrote:
Im looking for the 5 inch OD Pulley Sheave for the HDX-689. This is for the ¼
in cable. I need to order a few of these as I'm replacing all the cables on the
tower right now. I know US Towers had them, but wanted to see if anyone else has
replaced them from another vendor for a better price.
Thanks...
Rich
Rich N7TR
ex KI3V, N3AMK, WB3JOV
www.n7tr.com<http://www.n7tr.com>
http://www.qrz.com/db/N7TR
Telnet: dxc.n7tr.com N7TR DXCluster
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|