Towertalk
[Top] [All Lists]

Re: [TowerTalk] My situation: Is lightning protection needed?

To: towertalk@contesting.com
Subject: Re: [TowerTalk] My situation: Is lightning protection needed?
From: K8RI <K8RI-on-TowerTalk@tm.net>
Date: Wed, 10 Jul 2013 14:13:58 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 7/10/2013 10:29 AM, Art Greenberg wrote:
The discussion about protecting networked computers is of interest to me
because I have been thinking about an application here. I thought I'd
start a new thread about my particular situation to see what others think.

I have an enclosed, air conditioned barn that I'd like to put my shack
in. The thinking is, I'd run an Ethernet cable to the house using an
existing buried conduit (that is now empty) and run the radio equipment
remotely. The conduit run is about 230 feet. I figure a total run of 300
feet or so to connect a switch in the barn to a switch in the house. Our
Internet service comes into the house.

Being in FL the ground is probably dry, even if it gets soaked a couple time a day. (Been there)

Using Cat 6, I'm using 2 runs of 130 feet with 9, 90 degree bends in PVC conduit running a gigabit network that is about 200 feet from end to end.

"Supposedly" you can get up to 300 feet, but that is one of those misleading statements where the key is the phrase "up to". Even 130 feet gets a bit fussy with bends "without kinks".


IF you can make it work, I'd want lightning protection on each end. I know, most of it is in conduit, run underground but two buildings that far apart AND on separate feeds (different transformers?) can be many thousands of volts apart just with a nearby strike. Although partially protected by being underground, if the soil is dry sand you will have no where near the protection we have up here with wet, heavy clay.

You have a lot of negatives:  A long run, near the limit for Cat6
You will have over 200 feet of copper wire between two different services in a lightening prone area

I don't know that much about fiber even though my field and degree are in CS. (I graduated in 1990) I'd really like to change to fiber for my whole network.


73

Roger (K8RI)


The barn has its own electric service. There is a shunt-mode "whole
house" surge arrestor installed in the load center. The service feeder
to the barn and the service feeder to the house come from completely
different directions. Both are above ground until they get close.

The antenna transmission lines to the barn would all be run through an
entrance panel with lightning arrestors, bonded to the barn's service
ground. All of the radio equipment would be grounded to the entrance
panel ground. The radio equipment would be very close to the load center.

If I can get a reliable gigabit network running between the barn and the
house, I could put some of my other computer equipment in the barn as well.

I'm in Florida, near Gainesville. Lots of lighthing, particularly during
summer.

Long prologue. Now the question.

I think its obvious that fiber would provide complete isolation between
the buildings. But would a copper cable (Cat5e, Cat6) with lightning
arrestors at each end be good enough? What strike scenarios would be
problematic?

Thanks all.

--
Art Greenberg
WA2LLN
art@artg.tv

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>