They are easy to find on EBAY. Just watch out which connector you need -
Spline, SDS, SDS-Max. They are not interchangeable. Do a search for
"rotary hammer drill". I lend my drill and bits out to radio club members
whenever needed. It's so rocky here we use the drills to drill holes for
T-posts and ground rods.
Gary J
N5BAA
HCARC Secretary 2013/14
-----Original Message-----
From: Mike VE3YF
Sent: Saturday, November 9, 2013 1:37 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Tower Base Anchor Bolts
Hi:
I have ran into a slight problem and need some help.
I am re-using my tower base for a new tower and the bolts that I
require are 1" x 27" and I have opted for the ASTM F1554 Grade 55, and
to leave 6" above the concrete which means 21" into the concrete.
However in my area all I can find for concrete bits that are 18" long
x 1.125" diameter.
However I can get a 22" bit x 1.250" Diameter
Is better to stay with an 18" x 1.125" hole and cut 3" off the bottom
of the bolt or go with a 22" x 1.250" hole and just add more epoxy.
Any help in this matter is greatly appreciated.
Tnx.
73 De Mike
VE3YF
http://www.ve3yf.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4158 / Virus Database: 3629/6816 - Release Date: 11/07/13
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|