Re: [TowerTalk] Comtek phasing controller - how to check the supported band?

[krishna kanakasapapathi <kkanakas@cisco.com>]

Thanks for the bandwidth. I now have my answer.
73s
krish
w4vku

On 11/10/2013 12:49 AM, krishna kanakasapapathi wrote:
> Howdie,
>  I have a few Comtek vertical phasing controllers here.
>  They have not been installed yet, but i would like to check them out 
> on the bench prior to deployment.
>   Is there a way to check the band that each one claims(product label) 
> it is built for.?
>  Appreciate any details.
> 73s
> krish
> w4vku
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk