This subscription has been ordered without my authorization. REMOVE
IMMEDIATELY.
Thank You,
Kelly
> On Jan 3, 2014, at 9:36 PM, Hans Hammarquist <hanslg@aol.com> wrote:
>
> Gentlemen,
>
>
> I don't know if i did something very wrong but I started but putting a large
> granite slab (6'x5'), 5 feet down where the tower was going to be. I had 12
> holes drilled in the slab and attached 6 angular irons, two screws per iron
> to the slab. I then place three "Sonar" tubes over the irons, two irons per
> tube and filled the tubes with cement. The tower legs were attached to the
> irons, squeezed in between the irons. (I put a few sections of the tower up,
> leveled them very carefully and then drilled holes for the bolts through the
> irons and the legs.
>
>
> The tower is anchored in the granite slab and the slab is secured with dirt.
> (I added some scrap iron to that dirt, just to make it heavier.) I have
> provided the link to photos of the work many times and am doing it again.
>
>
> https://www.facebook.com/media/set/?set=a.10150198503693539.328964.579753538&type=1&l=b4a8463457
>
>
> Did I do something stupid? Please tell. I used a lot less cement that way.
>
>
> Hans - N2JFS
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|