Towertalk
[Top] [All Lists]

Re: [TowerTalk] screw anchors (was Welding Rebar)

To: "john@kk9a.com" <john@kk9a.com>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] screw anchors (was Welding Rebar)
From: Wayne Kline <w3ea@hotmail.com>
Date: Tue, 7 Jan 2014 12:41:57 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
When I built my previous home, the power co. PPL  installed a pole and pole 
mounted transformer. In no time the pole was tilting/listing down the hill from 
the main lines.   they then drove up the hill with there utility truck with  
had a arm with this hydrolytic transmission. The operators attached this female 
drive  adaptor then screwed it on to a 10 ft guy ANCOR .
 One end was threaded and the other had a one sided  tapered wing.
 
    He lifted it up and positioned it at about 45 deg to the  pole and .. WOW 
spun it down to almost ground level ( it was higher then reg ground with the 
pulled up shale. unwound the adaptor started a one eye end and then screwed 
that on with the machine.
 
   Were was this marvelous machine when I needed it .  I dug two tower bases 
and 6 guy anchor holes by hand in SHALE
in the upcoming year... and that is NO fun ....   how do you spell PIC Bar ? 
 
Wayne W3EA 
 
 
 
 
 
ate: Tue, 7 Jan 2014 11:56:52 -0500
> From: john@kk9a.com
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] screw anchors (was Welding Rebar)
> 
> I agree that screw anchors can work fine for a guy anchor. Finding an
> installation machine or attachment to properly set them may be the
> challenge.
> 
> John KK9A
> 
> To:   towertalk@contesting.com
> Subject:       [TowerTalk] screw anchors (was Welding Rebar)
> From:  Hans Hammarquist <hanslg@aol.com>
> Date:  Mon, 6 Jan 2014 16:00:44 -0500 (EST)
> List-post:     <towertalk@contesting.com">mailto:towertalk@contesting.com>
> I don't see any problems with screw anchors. Anyone what havae had any
> problems
> with them The one I use are, according to the manufacturer's spec., good
> for a
> pulll force of 14,400 # in undisturbed,dry sand.
> 
> 
> Hans - N2JFS
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

                                          
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>