It's not clear if their calculation indicates survival (won't bend) or failure
(opps!) rating.
-Mike-
WA6ZTY
>________________________________
> From: Tim Jellison <kl7wv@kl7wv.com>
>To: towertalk@contesting.com
>Sent: Saturday, January 11, 2014 8:43 AM
>Subject: [TowerTalk] Tower mast calculator
>
>
>DX Engineering just put a nice little utility on their website to
>calculate loads on a tower mast. It's pretty handy when trying to
>figure out what antennas a mast pipe can handle.
>
>http://www.dxengineering.com/mastloadestimator?ibanner=DXEHPB1401001
>
>73,
>Tim
>
>--
>Tim Jellison W3YQ/KL7WV
>KL7WV Tower Service
>304 704 1196
>kl7wv@kl7wv.com
>www.kl7wv.com
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|