Towertalk
[Top] [All Lists]

Re: [TowerTalk] The details of wiring a homebrew AZ/EL rotator

To: Nate Bargmann <n0nb@n0nb.us>
Subject: Re: [TowerTalk] The details of wiring a homebrew AZ/EL rotator
From: Lizeth Norman <normanlizeth@gmail.com>
Date: Sat, 25 Jan 2014 13:22:26 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The rotator is complely homebrew. Cables carry various DC signals. One
cable carries 2 motor poles (4 wires), the other carries a 3 wire sensor
set with ground and +5Vdc (total 5 wires)


On Sat, Jan 25, 2014 at 1:02 PM, Nate Bargmann <n0nb@n0nb.us> wrote:

> * On 2014 25 Jan 11:16 -0600, Lizeth Norman wrote:
> > I have double shielded 18Ga 4 twisted pair wire.
> > When I terminate the wire, what do I do with the braid shield. There will
> > be 40W UHF or 50W VHF max around, so the idea of protecting my sensor's
> (5V
> > ttl) wiring is something I'm concerned about.
>
> Ordinarily I would think that grounding one end would be the correct
> thing to do.  As I've not done what you're doing on a tower, I would
> consider bonding it to the tower ground at the bottom where it breaks
> away to the shack and not bond it to ground at either of the terminating
> ends.  It seems that would drain off lightning static and any stray
> transmitted energy.
>
> Does the controller manufacturer offer any suggestions?
>
> 73, de Nate >>
>
> --
>
> "The optimist proclaims that we live in the best of all
> possible worlds.  The pessimist fears this is true."
>
> Ham radio, Linux, bikes, and more: http://www.n0nb.us
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>