Towertalk
[Top] [All Lists]

Re: [TowerTalk] Odd T2X behavior RESOLVED

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Odd T2X behavior RESOLVED
From: Kim Elmore <cw_de_n5op@sbcglobal.net>
Date: Wed, 02 Apr 2014 20:26:45 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I wanted to let anyone curious know that my odd T2X behavior has been resolved. After speaking with Jeff, W2FU, I learned that Green Heron controller can be susceptible to AC induced on the direction signal line. This can occur under various conditions and I apparently enjoy at least one of them. The fix is to install a 100 uF capacitor between terminals 4(+) and 3 (GND). I did so and now everything is smooth as silk.

Kim N5OP

On 4/2/2014 9:49 AM, Kimberly Elmore wrote:
I have two T2X rotors and just replaced one that jammed with one I have 
recently rebuilt, complete with a new direction potentiometer. All was well 
until a couple of days ago, when I noticed that approaching the CW end of 
rotation, I couldn't get a direction indication beyond about 160 deg yet, when 
the brake disengaged, the direction indication went to 180 deg. Playing with it 
some, the problem has worsened such that I don't get a good direction 
indication much south of about 120 deg or so, though it clears up when the 
brake is disengaged. I initially thought it was contaminates on the wiper arm, 
but the change in direction indication is so consistent with brake actuation 
that I am no longer confident that contamination on the wiper arm is the 
problem.

The rotor has the AMP connector installed and tested good on the ground. I'm 
using a Green Heron RT-21 controller.

I'm beginning to suspect either a bad connection in the ground pin of the rotor. After 
insuring that the basic resistance checks yield nominal values, I plan to go up and 
visually inspect the connector and plug. An "out there" scenarios is if, for 
some reason, the internal common ground developed a problem under brake activation (due 
to excessive, but not outrageous, resistance) brake current could be divided between a 
poor ground and the the grounded wiper of the direction potentiometer, yielding both a 
burned up direction potentiometer (at least on one end) and strange direction 
indications. Has anyone ever seen problems with the *internal* grounding of the T2X or a 
direction indication vary considerably related to brake actuation?

Kim N5OP
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>