Towertalk
[Top] [All Lists]

[TowerTalk] Fwd: Re: Utility Pole as Beam Support

To: TOWERTALK@contesting.com
Subject: [TowerTalk] Fwd: Re: Utility Pole as Beam Support
From: Herb Schoenbohm <herbs@vitelcom.net>
Reply-to: herbs@vitelcom.net
Date: Wed, 04 Jun 2014 07:38:58 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>





Depending on the top diameter of the pole a top section of a Rohn 25 can
fit over the top and be securely bolted or lagged in place  This makes
the antenna mounting and rotor plate easier to work with and give some
side load thrust support.  It also gives the climber a more secure
working area rather than just pegs at the top of the utility pole.


Herb Schoenbohm, KV4FZ


On 6/4/2014 12:40 AM, W0MU Mike Fatchett wrote:
If you have a rotor that has bottom assembly that you can attach to a
mast then buy a 10 ft section of heavy duty Schedule XXXX pipe and
bolt it to the top of the pole. Mount your rotor on that and then the
beam above the rotor on a short mast.

You can put steps in the pole to climb up or rent a bucket truck.

Does Hazer or someone like it make a rail system to raise/lower
antennas on poles?

Mike W0MU

On 6/3/2014 4:15 PM, Clay Jackson wrote:
I just "inherited" a 50' (out of the ground, 6' buried) utility pole
(crew
was taking it out and told me that if I'd drag it off the road, I
could have
it).

I'm thinking about trying to find a rotator and tri-bander to put on
top of
it; but, having no experience with such a setup; I thought I'd seek some
advice first.

So, a few questions.

I'm sure someone has done this before;  would you be able to share your
experiences?

I have a friend who can weld anything from steel to aluminum and so I
think
we can fab up a mount for the rotor.

Beyond that, thoughts would be appreciated on things like:
Wind loading - how many sq ft (if any) is reasonable before I have to
use
guys (for my HyGain AV18HT the building dept made me engineer the
base for
90K winds, WITH a "wet stamped" drawing)?
Base - is a 6' hole filled with dirt "good enough" or do I need
something
more (if more, would a  6' hole with concrete be sufficient)?

Thanks in advance!

Clay
N7QNM





_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>