Grant wrote:
>>> What are the best ways to model conductive boom clamps in NEC2 or NEC4
>>> (EZNEC+ or EZNEC PRO4)?
One way is to use the "equivalent diameter" concept as explained in Sec 9.1 of
Leeson's "Physical Design of Yagi Antennas". If you decide to go that route
the math is incorporated in the AutoEZ "Clamps" dialog:
http://ac6la.com/aecr9.png
A more complete explanation of how to use this dialog may be found in the first
section of this page:
http://ac6la.com/aecreate.html
The "Clamps" dialog is included in the free demo version of AutoEZ. You are
more than welcome to use the free version to calculate the equivalent
diameter(s) and then manually transfer the results to an EZNEC (.ez) model.
Dan, AC6LA
http://ac6la.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
