Kelly, a 10ft piece of 2" or so OD pipe or tube can be cut to three equal
lengths, Then you can drill holes to match the tower legs and bolt them
together. Probably best to use grade 8 bolts.
The old Rohn BXHC78 hinged base used three pieces of pipe like that to
interface the tower legs with the base hinges.
73,
Gerald K5GW
In a message dated 9/5/2014 9:44:00 A.M. Pacific Daylight Time,
ve4xt@mymts.net writes:
Hi all,
I¹m not seeing any evidence of my posts going through, so if this is a
duplicate, please forgive.
Need base stubs, or a suitable MacGyver, for a DMX48. This is a
freestanding
tower similar to the Rohn BX, but with a tapered design rather than the
BX¹s
stepped taper.
My stubs would attach to the old-style DMX106 section.
Delhi changed the leg profile enough that new stubs, apparently, according
to Delhi, don¹t work.
Seems all the old-style stubs are currently residing in concrete. Just like
mine still in the ground at my parents¹ former home...
Thanks
Kelly
ve4xt
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|