All:
A peculiar thing happened with my Yaesu 2800 rotor controller today. The
rotor kept returning to it's preset position after turning it either
clockwise or counter clockwise. It also moved very slowly.
My first thought was that the preset circuit must be bad, but then I
noticed that the problem went away when I pulled on the preset button.
It turned out that the button itself was jammed. Tapping on it a few
times allowed it to return to it's normal position.
I noticed what appeared to be a tiny piece of plastic which could have
worked it's way into the button causing it to jam. Might be a fluke, but
thought I'd pass it on.
Tony -K2MO
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|