Hi Guys,
Getting ready to put up my KT-34XA this weekend and just trying to get the
balun right. I have been experimenting this week with cores and windings and
have found a combo that sure looks good on the MFJ-259 and seems to not get
too hot on a soak test...what I have come up with is a core from Arnolds MPP
series which is 125u, 2" diameter and with 8 turns 14ga enamel with
Fiberglas tape spacers, bifilar wound for each half ,on one core, I am flat
from 1MHz-45MHz with the MFJ-259. Running 500W through it for 5 minutes gets
it hot, but I can still hold it. I want to end up winding it on 2 cores,
half on each and am wondering if I should use the same # of turns on each
core as I would if it were a single core, ie 8 turns on each core, then
connect to make it a 4:1, or do I need to modify the turns count when I
split to 2 cores? Also, when splitting to 2 cores, do they need to be
oriented in any particular way or can I stack them one on top of the other,
like 2 doughnuts? The antenna is all rebuilt and tested with my single core
balun....just need some + temps and no snow for the weekend.
Your advice is greatly appreciated.
73
Paul
VE7KHz
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|