Towertalk
[Top] [All Lists]

Re: [TowerTalk] Some advice about crimp ;type coax connectors

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Some advice about crimp ;type coax connectors
From: "Stan Labinsky Jr." <K2STN@frontier.com>
Date: Wed, 19 Nov 2014 02:03:33 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Now if you want to talk butane soldering irons, let's take a look at those from Master Appliance.

I have a Solder Pro 120, have used it for years. Used it to solder 58U cable to 3/4" Motorola (NMO) mounts. Nice iron... but! In the winter it juuuuust about almost had enough heat to do the shield connection using the biggest flat blade tip available. As long as it wasn't too windy.

The big Master guy on the other hand... he's like an old fashioned 100 watt plug-in soldering iron, the kind with a two prong plug, cotton covered cord and a half inch diameter copper tip. You touch it to the work, the solder flows! Don't care how cold it is outside. Well, actually I do, it gets awfully uncomfortable up in the crosswind on top of a school bus roof in the winter. But hey, that's where the antenna is, it's been torn out of the roof and the mount's shot... well, it's a living.

The only fly in this ointment? Cost! The Master goes for about 4 times the 120's price. But when it's needed, it's well worth it!

Oh, BTW, watch the kind of fuel you buy. Have used some supposedly good stuff which was contaminated with... well, I forget what the Solder Pro folks said that it was They even commented that for a short time the contaminated fuel was even ruining brand new irons as they were being tested at the factory, or so I was told when I tried to send mine back for warranty service many years ago. They, instead, sent me a new valve and orifice assembly... the bad ones were literally gummed up with a jelly like polymer goo. The only stuff I was told to use was the Master Appliance fuel. That I buy from Grainger.

Stan


-----Original Message----- From: W3YY
Sent: Tuesday, November 18, 2014 10:36 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Some advice about crimp ;type coax connectors

Weller also makes one like that.  I have one and it works great on top of
the tower, though I am trying to move toward other kinds connections up
there whenever possible.

73, Bob - W3YY
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>