HI Wilson
The coax jacks are already mounted with nuts and bolts to the inside of
the tuner where there is no paint, just aluminum. The suggestion with
the cliplead sound like a good idea. I'll give that a shot after the
RTTY Roundup. 73
Tom W7WHY
On 1/3/2015 9:19 AM, Wilson wrote:
Make a short cliplead to go from cap frame to shaft. Set SWR and leave power
on. When SWR drifts, connect the cliplead, first on one cap, then the other.
If it helps, you may be able to retension the bearing fingers. If not, use a
big electrolytic cap and spotweld some small braid across the bearings.
Check cap mounting nuts.
I had the rivet problem, fixed with two screws/connector. One would be fine
too.
WL
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|