Towertalk
[Top] [All Lists]

Re: [TowerTalk] Yaesu G-2800DXA

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Yaesu G-2800DXA
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
Date: Sun, 12 Apr 2015 03:12:47 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
If you live in an area with freezing temps, a collar to keep water out of the tube so it won't freeze up.

73

Roger (K8RI)



On 4/11/2015 4:51 PM, Chuck Dietz wrote:
I use a tube top section with the rotor on a shelf just below the tube.
That way I don't need a bearing.  When I need to change a rotor, I clamp a
U bolt at the top of the tube to hold the mast.

Chuck W5PR

On Sat, Apr 11, 2015 at 3:46 PM, Chuck Dietz <w5prchuck@gmail.com> wrote:

Yes

Chuck W5PR

On Sat, Apr 11, 2015 at 3:38 PM, Mike Reublin NF4L <nf4l@comcast.net>
wrote:

Can it be put thru the side without cutting a brace?

Mike NF4L

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
Drax Felton
Sent: Saturday, April 11, 2015 13:45
To: Rex Turvin; Towertalk Reflector
Subject: Re: [TowerTalk] Yaesu G-2800DXA

Absolutely it will fit

Sent from Outlook
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>