Towertalk
[Top] [All Lists]

Re: [TowerTalk] choke / balun design needed

To: jim@audiosystemsgroup.com
Subject: Re: [TowerTalk] choke / balun design needed
From: Alex Malyava <alex.k2bb@gmail.com>
Date: Mon, 27 Apr 2015 12:50:32 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks Jim,
I will read that :)

Most likely, facing the frying problem, I will go with simple dipole or
vertical delta.

On Mon, Apr 27, 2015 at 12:41 PM, Jim Brown <jim@audiosystemsgroup.com>
wrote:

> On Mon,4/27/2015 6:50 AM, Alex Malyava wrote:
>
>> What would be the bestest design for choke or balun to be used with dipole
>> or OCF dipole?
>> Like what type of core, number of turns or number of beads?
>>
>
> k9yc.com/RFI-Ham.pdf
>
> See the Choke Cookbook and text that precedes it.
>
> An off-center fed antenna is inherently poorly balanced, so it puts a high
> common mode current on the feedline, which in turn places a high common
> mode voltage across any choke. It is well known that even very good common
> mode chokes are likely to fry (fail destructively) when used with even
> moderate power levels. You MIGHT get away with it at 100W, but at some
> higher power level it WILL break.
>
> 73, Jim K9YC
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>