I haven't seen anything about a COTS 40M HexBeam but I have built a
couple Hex Beams covering 6-20M and scaling up to 40m as a DIY project
isn't too far into the unknown.
There are pulltruded fiberglass sucker rods available on the used market
for decent prices. The problem is shipping. They are typically 1 or
1.2 inches in diameter and are 37.5 ft long. There are other sizes.
There are threaded metal fittings epoxied onto the ends, one is female
and the other male threads. Sometimes I just cut these to length and
may keep or cut off te metal fittings. These rods are very stout but are
easily cut with an abrasive cut off blade in an angle grinder. I have
the "center?" of my off center dipole raised up using a length of pipe
with one of these inserted into it. These rods look like they would be
good for quads, hex beams and such.
I can buy these in OKC but have to cut them to a max length that I can
handle on my truck's ladder rack which extends over the 4 door cab.
This is about 25 ft.
This is one of many hits.
1" & 1.2" Used*Fiberglass Sucker Rod*, Custom Cut by SWPF ...
<http://southwestagriculturesupplies.com/products/1-used-fiberglass-sucker-rod-custom-cut>
http://southwestagriculturesupplies.com/products/1-used-fiberglass-sucker-rod-custom-cut
Best of luck to you with your project.
Patrick NJ5G
On 9/9/2015 9:11 AM, dw wrote:
Hi All,
Does anyone have any experience with the spiderbeams?
I would really like to put up something light-weight for 40 meters.
I believe the spiderbeam 40m unit is only 17 pounds.
Not sure if anyone makes a hex for 40m.
But I think Array Solutions may now have a moxon for 40m.
I might be tempted to build myself if I knew I could get fiberglass
sections long enough for a 40m unit.
Thanks :-]
N1BBR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|