Re: [TowerTalk] clamp on trhust bearing

["Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>]

Thrust bearing to support lateral loads, or to take load off the rotator 
for changes?  Split blocks work great for lateral loads.  Oil soaked 
hard wood, or high density PE.
73

Roger (K8RI)

On 11/1/2015 6:20 AM, Jorge Diez - CX6VM wrote:
> Hello
>
>   
>
> I have a yaesu 065 thrust bearing broken up in the tower, after a rotor
> replacement.  Inside a mast with two antennas
>
>   
>
> I don´t want to remove all antennas and mast to replace the thrust bearing
> from 200 ft tower, so wondering if there´s a CLAMP ON thrust bearing or
> crapodine I can get to replace it without need to remove all antennas and
> mast
>
>   
>
> Thanks,
>
> Jorge
>
> CX6VM/CW5W
>
>
>
> ---
> El software de antivirus Avast ha analizado este correo electrónico en busca de 
> virus.
> https://www.avast.com/antivirus
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk