From Jim's post it could be Delrin. I'll know when I give it the heat
test. I have a number of 1" Delrin rods about a foot long, but they arr
not white, but rather an off color that is close to white but would
never be mistaken for white. When working as a tech, I made a number of
low speed bearing out of it in an attempt to reduce vibration in float
zone refiners. IIRC It doesn't cold flow like Teflon, but that was well
before 84. Probably in the late 60s or early 70s.
73
Roger (K8RI)
On 5/7/2016 Saturday 11:54 AM, jimlux wrote:
On 5/7/16 7:01 AM, Richard (Rick) Karlquist wrote:
On 5/6/2016 6:36 PM, Don W7WLL wrote:
After reading specs that the Amphenol used PTFE
(all of my Amphenol of a later vintage appear to be clear insulation)
Don T
Where did you read that Amphenol used PTFE?
I have never heard of that.
BTW, PTFE is never clear, AFAIK.
PTFE is usually a solid white
a sort of translucent clear is often polyethylene (or high density PE)
- low melting point, but no halogens, so burning it is like burning
wax, you'll see this in "plenum rated" cables, because it doesn't
create a toxic smoke hazard when a building catches fire
Phenolic - a thermoset plastic (e.g. Bakelite, it's been around for
over a century) which usually has a filler (wood in the case of
Bakelite). I've seen UHF connectors with a phenolic fabric dielectric
(you can see the weave), it's probably linen for the fabric, since
that's what was used for "precision" components. Circuit board
material (XXP, for instance) used paper as the filler.
Diallyl Pthalate is a popular dielectric - it's rugged, but I don't
know if it's used much in RF connectors - typically it's blue or
green, in connectors like Submini D. It's also used in high voltage
connectors.
Connectors which use phenolic often have an "upgraded" version using
Diallyl Pthalate.
There's been changes in manufacturing since the UHF connector was
introduced pre WW-2
https://www.google.com/patents/US2422982
https://www.google.com/patents/US2335041
Back then, you'd machine stuff and assemble it.
Now, injection molding and form in place might be more common - it's a
LOT cheaper.
PE is trivially injection molded - Phenolic is "machine and assemble"
PTFE can be sort of molded: they sinter a powder in a mold, but you
can't injection mold it.
In any event, PTFE is greatly inferior
mechanically, and has no electrical
advantage at HF, or even UHF. It's
high temperature rating is also of no
consequence for most ham applications. I
don't know why any knowledgeable person
would even want it, except in some
corner case like a common mode choke
made with PTFE coax.
Rick N6RK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|