Hello all:
I have a KF7P MetalWerks cable entrance panel (great panel) that I
previously had mounted on the side of my brick house. I now have a house
with vinyl siding. The hole for the cables to pass into the house is on
the back of the panel. I want to properly mount this and drill and seal in
such a way as to prevent leaks. I would appreciate any advice. I am going
to put up a Windom, a 2/440 vertical and a Diamond Discone.
Also, my new shack is on the second floor so any advice about lengths of
ground wire would be appreciated. I have 2 inch copper strapping that I
will be using to run a bond to the house electrical ground.
Thanks and 73
John
N4DOU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|