Towertalk
[Top] [All Lists]

Re: [TowerTalk] Biggest rotor that will fit in a Rohn 25G

To: "towertalk" <towertalk@contesting.com>, "Steve Maki" <lists@oakcom.org>
Subject: Re: [TowerTalk] Biggest rotor that will fit in a Rohn 25G
From: "Jeff AC0C" <keepwalking188@ac0c.com>
Date: Thu, 21 Jul 2016 08:39:30 +0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks for the guys who have replied so far.

The top section is a flat top with a bearing. The rotor would sit down at the junction of the first and second section point.

The antenna under consideration is probably something like a Tennadyne T12 covering 10-30m, 36 foot mast, 53' max element and about 150 lbs. 16 sq ft if I remember right. I may stick a small 6m beam up above the T12 but that would not offer much in the way of wind loading compared to the LPDA, other than the contribution to torque felt by the top mast bearing.

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

-----Original Message----- From: Steve Maki
Sent: Thursday, July 21, 2016 5:34 AM
To: towertalk
Subject: Re: [TowerTalk] Biggest rotor that will fit in a Rohn 25G

On 7/20/2016 17:26 PM, Bill Tippett wrote:
K8RI:  > A heavy duty rotator with a large antenna should be mounted well
down into the tower. Mounted at the top, in the tapered section would
likely put very high stress at that point.

I mounted my rotator at the same point in 45G and had no problems for >10
years with the antennas/wind speeds in Colorado described previously.  If
still concerned, you could mount a straight 25G section above a straight
25AG4 and install the rotator in the 16" window.  Of course this would
require a long mast (~15').  I don't know which LPDA Jeff is considering
but I doubt it's >32 sq. ft.

And besides, the rotational torque will be resisted by z-braced sections
below the rotator.

The only concern with the normal R25 rotator mounting position is
lateral loads encountered with tall masts. I've seen pointy top sections
fold over in that scenario.

-Steve K8LX

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>