Some ops will stack yagis at the top of each crank-up section.
The 472 has 4 sections, about ~20 foot each
A two tribander yagi stack of about 72ft over 38ft would work well.
Some have even gone to the extent of mounting a ringrotor to the
tower at the top of the second section in order to turn that bottom yagi.
Other combinations will be useful with monobanders.
Good luck with your project.
----- Original Message -----
From: "FritzOAQ" <fritz@k4oaq.com>
To: "TowerTalk" <towertalk@contesting.com>
Sent: Monday, July 25, 2016 12:11:28 PM
Subject: [TowerTalk] stack yagis on US Tower TX-472MDP?
Before I spend the energy moving my 25G 100 miles from one QTH to another, I
thot I'd ask the question if stacking yagis (only one abt half way up) on a
UST crankup is a possibility. If yes, then can it still be cranked down? If
not cranked down all the way, then enough to tilt over?
73,
Fritz K4OAQ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|