Re: [TowerTalk] LMR600 male DIN

[Bob K6UJ <k6uj@pacbell.net>]

thanks Perry,

I watched several videos on installing the crimp connector.  Doesn't 
look that difficult.
The crimp style are cheaper too.........

Bob
K6UJ




On 9/2/16 5:54 PM, Perry K4PWO wrote:
> http://www.l-com.com/coaxial-7-16-din-male-crimp-connector-for-600-series-ca
> ble
> I haven't used these but they look OK.  I have used a lot of the crimp "N"
> and they are great.
>
> Perry K4PWO
>
> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Bob
> K6UJ
> Sent: Friday, September 02, 2016 2:37 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] LMR600 male DIN
>
>
> I am looking at this DIN connector for LMR600.
> What do you think of this connector ?  Price is not bad.
> Crimp style OK, or would I be better off with clamp style ?
> I will be making multiple runs a little over 300 feet each out to the tower.
> Bear with me guys, I haven't ventured into the N or DIN connector use
> before.
>
> https://www.pasternack.com/7-16-male-standard-lmr-600-pe-c600-connector-ez-6
> 00-716m-x-p.aspx
>
>
> Bob
> K6UJ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk