Re: [TowerTalk] C19XR Feed Point Parallel Wire Connection.

[Tom Carrubba KA2D <ka2d@arrl.net>]

Roger

Use 10-2 or 12-2 romex from your favorite box store

Tom KA2D


On 11/11/2016 6:13 AM, Roger (K8RI) on TT wrote:
> The driver assembly instructions for the C19XR say:  " The next part 
> installs the parallel driver wires between the 10 mtr driver feed 
> points and the 20 mtr feed points"  I do not have this part, or even a 
> photo.
> Outside of ordering this part and waiting-- Would a piece of 450 ohm 
> ladder line work for this?  Otherwise, what would be better?
> 73
>
> Roger (K8RI)
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk