Towertalk
[Top] [All Lists]

Re: [TowerTalk] Spacing at center of K1WA/K3LR array

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Spacing at center of K1WA/K3LR array
From: jimlux <jimlux@earthlink.net>
Date: Mon, 28 Nov 2016 12:46:02 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 11/28/16 11:34 AM, jimlux wrote:
On 11/28/16 11:10 AM, Mike Smith VE9AA wrote:
Greeting Antenna Gurus,

Here's the model

CM Tower with 4 vertical V dipoles          ' Comment cards

CM based on K3LR's article in 1994 QST

CE ' End of comment

'

SY TH=190/3.28'tower height

SY TR=1/3.28      'Tower Radius

SY DL=131/3.28 'Dipole element length

SY DA=45             'dipole angle

SY DR=.001          'Dipole radius (1mm)

SY DS=95/3.28   'Spacing from tower for center of dipole

SY DH=95/3.28   'height of dipole center above ground

SY FL=175/.78/3.28          'Feedline length

GW 101 101 -sin(DA)*DL 0 cos(DA)*DL 0 0 .1 DR ' Wire 1, upper part

GW 111 101 0 0 -0.1 -sin(DA)*DL 0 -cos(DA)*DL DR

GW 121 1 0 0 0.1 0 0 -0.1 DR 'feedpoint

GW 122 1 1 0 0.05 1 0 -0.05 .001

GM 0 0 0 0 0 DS 0 DH 0 'move dipole away from tower and up to height

GM 100 3 0 0 90 0 0 0 'make 4 copies

GW 900 100 0 0 0 0 0 th tr 'tower

GE          1

'

GN 2 0 0 0 13 0.005

EX 0 122 1 00 1 0 ' Voltage source (1+j0) at wire 1 segment 51

TL 121 1 122 1 50 FL 'transmission line

TL 221 1 222 1 50 FL

TL 321 1 322 1 50 FL

TL 421 1 422 1 50 FL

LD 5 0 0 0 58000000 '20% of copper (steel)

LD 5 900 0 0 37700000 'Tower

LD           0              222         1              1              1e6

LD           0              322         1              1              1e6

LD           0              422         1              1              1e6

'

FR 0 1 0 0 1.84 0 ' Set design frequency (300 Mc).

'

EN

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>