Towertalk
[Top] [All Lists]

Re: [TowerTalk] Datasheet for Rohn TA-55

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Datasheet for Rohn TA-55
From: Steve Maki <lists@oakcom.org>
Date: Fri, 6 Jan 2017 17:09:51 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I've mentioned this very point here in the (distant) past, when there were folks anguishing over whether they needed to reduce rotational torque on their tower. And others worried about shock loads on rotators. Maybe they do from an engineering standpoint...but noting that there are many 150'-200' heavily loaded 18" rotating towers still standing after many years can serve as a sanity check about needing star guys.

That said, tall 18" towers (without star guys) DO twist a lot. If you stand at the base of one during high winds and look straight up, you'll see yagis pointed every which way but south, simultaneously. That tends to be a good thing as far as shock loads on rotators - the tower itself acts as a shock absorber.

Not good though if you're trying to keep a high gain UHF yagi or dish on target.

-Steve K8LX

On 1/6/2017 12:32 PM, Jim Thomson wrote:

##  heres the part that I dont get.   The 6 point guy system will reduce on the 
tower
where the..cue rack is installed... almost down to nothing.   Is torque even an 
issue ?

##  these rotating towers  all use rings..and the typ 3 guy wires per ring..are 
attached  to the
ring.... not to the tower.   IE:   There is nothing to stop the tower from 
torquing at all !
The guy wires on the rotating towers just hold up and support the tower, they 
dont provide
any torque redux  at all.     Then folks install 188-220 ft tall rotating tower 
assys... with the
usual myriad of large HF yagis on them, typ with a 80m yagi  at the very top.

##  meanwhile the rotor is at the very bottom, like on the K0XG setups.   The 
tower appears
to me to be one big.... mother of all torque wrenches.  The myriad of yagis are 
all bolted to
the same tower face too.  How much to these rotating towers actually twist in 
high winds ???

##  If twist is a non issue on a rotating tower, then why even mess with the 
...cue-rack..aka
rohn TA55  assy at all ??   What am I missing here ?

Jim   VE7RF

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>