The part number I gave was stainless steel, which is all I use. U-Bolts can
be reshaped so perhaps a 2 1/2 or 3" wide one squeezed down would be of
adequate length. Since you are using saddles, another option may be just
use a Stauff clamp half and hex bolts, which are available in any length.
John KK9A
To: "Towertalk" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Long Tangent U Bolts
From: "Don W7WLL" <w7wll@arrl.net>
Date: Mon, 10 Apr 2017 14:13:19 -0700
4 inch won't do it, no room for a saddle, plate and fasterners. I was
really, I guess, seeking a ham known reputable and reasonable cost source of
custom U bolts and that was why I was wondering if U-Bolt-It was used by
anyone. I know what standard lengths and sizes are available from the
catalogs, but for the other needs . . . . . . . plus nothing goes outside
here unless it is SS if I can help it.
Don W7WLL
-----Original Message----- From: john@kk9a.com
Sent: Monday, April 10, 2017 11:40 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Long Tangent U Bolts
I guess it depends on what you call long. McMaster-Carr has 2" U-Bolts
that are 4" long https://www.mcmaster.com/#29605t45/=175136e
John KK9A
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|