Towertalk
[Top] [All Lists]

Re: [TowerTalk] Wire antenna in trees? (Patrick Greenlee) (Kelly Taylor)

To: David Gallatin <kc9eev@yahoo.com>, john@kk9a.com, towertalk@contesting.com
Subject: Re: [TowerTalk] Wire antenna in trees? (Patrick Greenlee) (Kelly Taylor)
From: Grant Saviers <grants2@pacbell.net>
Date: Sun, 6 Aug 2017 12:26:33 -0700
List-post: <mailto:towertalk@contesting.com>
Yes, and after a year or two in the sun the nylon rots and flakes off and changes the RF length a bit with less insulation thickness.

For me the DavisRF polyethylene insulated copperweld stranded steel is the Cadillac solution. It survives coastal environments. As good but much cheaper is bare aluminum electric fencing wire 9 or 12 1/2 ga, buy it 1k ft to 1/4 mile at a time. Easy to kink so I use it for antennas and elevated radials that go up and stay up. 1/4 mile of 12 1/2 ga is $60 at Home Depot. 500# break.

Grant KZ1W

On 8/6/2017 9:30 AM, David Gallatin via TowerTalk wrote:
THHN is in no way meant for use as exterior antenna wire. The nylon (N) coating is thin and stiff.


Sent from my Boost Samsung Galaxy S®4

-------- Original message --------
From: john@kk9a.com
Date: 08/06/2017  11:06 AM  (GMT-05:00)
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Wire antenna in trees? (Patrick Greenlee) (Kelly
   Taylor)

What is the advantage of this wire over THHN?  Flex-weave has hundreds of
copper strands, each strand is very small diameter.

John KK9A


To:     W1TR@yccc.org
Subject:        Re: [TowerTalk] Wire antenna in trees? (Patrick Greenlee)
(Kelly Taylor) (Jim Brown)
From:   Mickey Baker <fishflorida@gmail.com>
Date:   Sat, 5 Aug 2017 11:39:01 -0400

Here in Florida where high winds are fairly common, I use the Davis
FlexWeave insulated wire and, in the case of loops, "float" the wire,
allowing it to slide through insulators at the corners. I terminate it at
the ends with dipoles and use 5/16" UV stabilized Dacron line through
pulleys to weights keeping it taught. When the trees I use as supports
sway, the weights go up and down, keeping a standard load on the wire and
moving the friction point a bit to avoid single point wear.

It has been up over two years now, gale force winds on a number of
occasions and no failures! (Knock wood.)

Tough wire. Same as or similar to Wireman Silky.

73,

Mickey N4MB

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>