Just cut up an aluminum coke can. I used that for years without problems.
K4TO
> On Oct 2, 2017, at 3:00 PM, Charles Gallo <charlie@thegallos.com> wrote:
>
> On Mon, October 2, 2017 2:52 pm, Marv Shelton wrote:
>> What is a good source for the .03125” shim stock needed to make a 2” OD
>> mast centered in a T2X?
>>
>> Marv wa2bfw
>
> Probably next to impossible to find .03125 shim stock, as I've never seen
> shim stock down in the .00001 range
>
> Most likely you will have to use .030 shim stock, which is everywhere, and
> deal with being off a bit more that a thousandth of an inch, or less than
> 1/2 the thickness of an average human hair
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|