I have several of these connectors for $20 each plus shipping left over from a
project.
These are not crimp but compression, water tight and very high quality. I've
never had an issue with them.
If anyone is need of these connectors contact me off the reflector.
W1JCW@hotmail.com
73-
W1JCW
John
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
john@kk9a.com
Sent: Wednesday, October 25, 2017 10:49 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] 7-16 DIN Males for RG-213/214
The only ones that I have seen were $75+. Perhaps crimped ones are less.
If I need a DIN jumper I use FSJ4 cable, otherwise I use N or UHF connectors on
RG8 sized cables.
GL
John KK9A
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] 7-16 DIN Males for RG-213/214
From: Byron Tatum <bjtatum1@att.net>
Reply-to: Byron Tatum <bjtatum1@att.net>
Date: Wed, 25 Oct 2017 12:12:28 +0000 (UTC)
Hello- Does anyone know of a source of good quality reasonably priced
7-16
DIM male connectors, of solder/clamp type, that fit the RG-213/214 type
cables? I am planning some future feedline upgrades for my VHF/UHF antenna
systems and have a lot of 7-16 DIN female connectors for my newer versions 7/8"
and 1-5/8" Cablewave heliax. Thanks, Byron W5FH
_______________________________________________
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
https://eur03.safelinks.protection.outlook.com/?url=http%3A%2F%2Flists.contesting.com%2Fmailman%2Flistinfo%2Ftowertalk&data=02%7C01%7CW1JCW%40hotmail.com%7Cfb73a245ba7945b7001408d51bc00f48%7C84df9e7fe9f640afb435aaaaaaaaaaaa%7C1%7C0%7C636445434075895001&sdata=0kAxM%2F2H7dAWCk0E1596JF%2BYwlGWM97iz4PSt%2FRhgsM%3D&reserved=0
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|