To: | towertalk@contesting.com |
---|---|
Subject: | Re: [TowerTalk] VNA2180 CM Test Jig |
From: | Martin A Flynn <maflynn@theflynn.org> |
Date: | Wed, 10 Jan 2018 06:59:16 -0500 |
List-post: | <mailto:towertalk@contesting.com> |
http://www.cosmtec.com/products.asp?Page=3&pname=N+RF+Connector&pfid=4&flev=2&puid=14&N+RF+Connector.htm Martin, W2RWJ On 1/9/2018 9:52 PM, Martin Sole wrote: Yet they must be made. Bird, who may well make them for their own use mind, uses a 'N' - male 4 hole flange mount on some of it's dry dummy loads and maybe other products. I suppose if you really needed them :)Martin, HS0ZED On 10/01/2018 09:33, Paul Christensen wrote:Owners of the VNA2180 vector network analyzer may have an interest in a simple CM test jig I created using DipTrace PCB software. I recentlyordered a set of boards from Bay Circuits and if it works as planned, I'llmake the Gerber files available free of charge through my QRZ.com page. The board measures 3.3" x 0.75". A pair of in-line male BNC connectorsmount flush to the PC board. These are scarce items but can be found on the auction site. To the best of my knowledge, neither Amphenol, nor any otherlarge-scale RF connector manufacturer makes these special connectors, especially in an N style. That forced me to use male BNC PCB connectors which will adapt nicely to a common female BNC-to-Male N between-seriesadapter. I noticed that G3TXQ did something similar with his jig; perhapshe ran into the same issue. The board is single-sided copper and solder-masked with ample pour protection between the BNC center pin and surrounding ground plane. Connector centers are 2.5-inch to match the N connector spacing on the VNA2180. More info after the boards arrive... Paul, W9AC _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk_______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] New tower installation, RCM |
---|---|
Next by Date: | Re: [TowerTalk] TowerTalk] New tower installation, john@kk9a.com |
Previous by Thread: | Re: [TowerTalk] VNA2180 CM Test Jig, Martin Sole |
Next by Thread: | [TowerTalk] Tower on wheels, Norm n3ykf |
Indexes: | [Date] [Thread] [Top] [All Lists] |