AN Wireless HD 60 Self supporting tower (see: http://www.anwireless.com/for
more info, specs and present prices)
2 Rotor Mounting Plates (1 drilled for Prosistel PST 71/61)
1 Thrust Bearing Plate (drilled for a Peer 2 in., 2 hole, flange bearing)
1 60 ft. Safety Lifeline System with DBI-SALA Safety Sleeve and Carabiner
1 Full set of Step Bolts
1 Chrome-Molly 4130, - 2 inch OD, 1/4 inch wall - ~22 ft. mast
1 Prosistel PST 71 Rotor with original controller and an extra controller and
extra rotor to mast bracket, hardware and approximately 130 ft. of rotor cable.
$3650 for all.
The pending purchase of my tower fell through earlier this week. The tower was
removed yesterday and is on the ground in 6 x 10 foot sections. I'd prefer to
sell as a complete package. The tower will require a 5 foot concrete base
section and appropriate base (there is a potential to increase the height of
the tower by adding sections to the bottom). Photos available upon request and
I can also put you in touch with the climber/rigger who assisted me with the
removal and disassembly to provide further info on the condition of the tower.
Pick-up (only) required at my Westminster, MD QTH and will most likely require
a trailer or multiple trips with a pick-up truck. Please contact me off
reflector with questions.
73,
Ed K3DNE
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|