To: | towertalk@contesting.com |
---|---|
Subject: | [TowerTalk] Hy-Gain HG-70HD tower thrust bearing info needed |
From: | Gary Marks <gmarks@neo.rr.com> |
Date: | Thu, 3 May 2018 01:20:10 -0400 |
List-post: | <mailto:towertalk@contesting.com> |
I would like to use a DX Engineering thrust bearing (ball bearing) to replace the Hy-Gain bearing on my HG-70HD tower but I can’t remember what the bearing plate looks like. I don’t believe there is a bolt hole pattern of any type and I’m wondering if I can drill three holes in the tower bearing plate to make the DXE ball bearing work. Any suggestions or info would be appreciated. Sent from my iPad _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TowerTalk] Pulling cables through conduit -- results, Dave Sublette |
---|---|
Next by Date: | [TowerTalk] Looking for GUY RING for Rohn 45, Hector Garcia,XE2K |
Previous by Thread: | [TowerTalk] Pulling cables through conduit -- results, Dave Sublette |
Next by Thread: | [TowerTalk] Looking for GUY RING for Rohn 45, Hector Garcia,XE2K |
Indexes: | [Date] [Thread] [Top] [All Lists] |