MY reason for using odd multiples of ¼ wave feed line. Was all my antennas are
either Beta match or direct feed OWA. Purely resistive loads not capacitive
as in a beta match.
Speaking to Ken K1EA many years ago.. and others. he was the one who
strengthened the notion . @ odd multiply 1/3 wave transmission line Voltage in
minimum and current is maximum.
Wayne W3EA
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
________________________________
From: TowerTalk <towertalk-bounces@contesting.com> on behalf of Wes Stewart
<wes_n7ws@triconet.org>
Sent: Friday, May 4, 2018 4:07:32 PM
To: Richard (Rick) Karlquist; towertalk@contesting.com
Subject: Re: [TowerTalk] Coax Lengths for Stacked Yagis
I probably should have been a little more specific; there are some special case
exceptions.
Roy Lewallen says on page 6-15 in my 22nd Edition of the ARRL Antenna Book:
"The only cases in which the current (or voltage) delay is equal to the
electrical
length of the line are
1) When the line is flat; that is, terminated in a purely
resistive load equal to its characteristic impedance;
2) When the line length is an integral number of half
wavelengths;
3) When the line length is an odd number of quarter
wavelengths and the load is purely resistive; and
4) When other specific lengths are used for specific load
impedances."
Wes
On 5/3/2018 9:24 PM, Richard (Rick) Karlquist wrote:
> Isn't it true that for lines that have a length
> that is any multiple of a quarter wave,
> the phase shift when matched is the same as when mismatched?
>
> Otherwise, (1) is correct AFAIK.
>
> Rick N6RK
>
> On 5/3/2018 9:06 PM, Wes Stewart wrote:
>> Another point or two and then I'll shut up.
>>
>> 1) The expected phase shift in a line is only achieved when the line is
>> matched.
>>
>> On 5/3/2018 7:28 PM, Wes Stewart wrote:
>>> Quarter wavelength lines have the magical property that the output current
>>> is equal to the input voltage divided by the line Zo. So with multiple
>>> inputs tied together, and obviously having the same voltage, the output
>>> currents will be equal.
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|