Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn EP instructions: "Stake all nuts"; what does it mea

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Rohn EP instructions: "Stake all nuts"; what does it mean?
From: "J.P." <jp@ezoom.net>
Date: Sun, 16 Sep 2018 18:48:37 -0700
List-post: <mailto:towertalk@contesting.com>
Staking nuts refers to the practice of creating a notch in the nit and 
corresponding mating surface with a cold chisel and hammer. The will prevent 
the nut from rotating. Very common in critical assemblies. 

We do this on the castle nuts of AR-15sto prevent  them from walking out and 
the buffer tube becoming loose for example. 

https://www.practicalmachinist.com/vb/general/staking-bolt-prevent-loosening-277927/


J.P. W2XX/7

> On Sep 16, 2018, at 6:29 PM, <john@kk9a.com> <john@kk9a.com> wrote:
> 
> All of the bolts that came with my Rohn 65G tower had Pal nuts and I have
> also seen them used on Rohn 55G tower guy brackets.  I installed this
> hardware just as you suggested in your post. I cannot answer your staking
> question, I think that a tight galvanized bolt and nut plus a Pal nut is
> unlikely to loosen.
> 
> GL
> John KK9A
> 
> 
> To:    towertalk reflector <TowerTalk@contesting.com>
> Subject:    [TowerTalk] Rohn EP instructions: "Stake all nuts"; what
> does it mean?
> From:    "Richard (Rick) Karlquist" <richard@karlquist.com>
> Date:    Sun, 16 Sep 2018 11:12:04 -0700
> 
> 
> The instruction sheet that came with my Rohn guy
> equalizer plates states:
> 
> "Stake all nuts after assembly"
> 
> The kit of parts includes bolts, regular hex
> nuts, and "PAL nuts".  Assembly order is that
> the regular nut goes on first, then the PAL nut
> with the edge lip out.  IE, the flat side of
> it faces the regular nut.
> 
> Questions:
> 
> Do I torque the regular nut nice and tight with
> a wrench, then install the PAL?  Do I tighten
> the PAL nut finger tight, or gently tighten it
> just a little with a wrench.  I have no experience
> with these PAL nuts, but they don't look like
> they would withstand much torque.
> 
> Finally:
> 
> What does "stake all nuts" refer to????
> I am imagining whacking them with a hammer or
> something ... but that can't be right?
> 
> Note:  the Rohn drawing is dated "1964" :-)
> Been licensed since 1965 and have never seen PAL nuts
> before.
> 
> Rick N6RK
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>