Towertalk
[Top] [All Lists]

Re: [TowerTalk] Ham-IV rotor will not turn

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Ham-IV rotor will not turn
From: Ed G <ed.n3cw@gmail.com>
Date: Mon, 15 Oct 2018 13:09:44 -0400
List-post: <mailto:towertalk@contesting.com>
Hi Ron,
     How long is your rotator control line? What size wire do you use? Where is 
the motor start capacitor located (typically it is in the control box). How old 
is the capacitor?  Any chance of varmints chewing into the control line?  Can 
you hear the brake pulling in when someone at the control box tries to rotate 
the antenna? There is a reason I ask these questions…something to do with 
lessons-learned  😉 
     I installed a new motor start cap at the base of my tower, and no longer 
have trouble with my rotator not turning. My control line is probably 250 feet 
or so.  I paralleled the now-unused extra two wires from the control 
box-mounted start cap in the control cable with the brake wires.
--Ed—


Sent from Mail for Windows 10

------------------------------

Message: 6
Date: Mon, 15 Oct 2018 14:43:18 +0000
From: "Ron 'KF5JRA' Rosson" <kf5jra@oneinsane.org>
To: towertalk@contesting.com
Subject: [TowerTalk] Ham-IV rotor will not turn
Message-ID: <emee6df2e3-5b6c-4fba-9113-21525924171f@kf5jra>
Content-Type: text/plain; format=flowed; charset=utf-8

Went to go and try to work E6Y today and found out that I can not turn 
my rotor. So at lunch time when it got warmer I did what any good ham 
operator would do and started troubleshooting:
Check connection at the pigtail of the Green Heron (good)Metered out the 
pins at the plug (disconnected from the GH) (good)checked with original 
hygain controller (failed)Climbed up on the roof and loosened the bolts 
on the rotor for the mast to make sure thrust bearing was not seized. 
Mast and antenna turned like a champ.Tested rotor for rotation (failed)

So I put everything back the way it was and am now reaching out since I 
have exhausted my knowledge of what else to test before attempting to 
remove the rotor.

This antenna system has only been up just barely over two years, see 
(http://www.oneinsane.org/home/roof-top-tower-installed) the only thing 
I can think of is I am binding somewhere and like I mentioned I have 
exhausted my knowledge base.

Any ideas?

--
73 de KF5JRA
Ron
kf5jra at oneinsane dot org





---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>