Towertalk
[Top] [All Lists]

Re: [TowerTalk] TowerTalk Digest, Vol 191, Issue 11

To: towertalk@contesting.com
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 191, Issue 11
From: Don <w7wll@arrl.net>
Reply-to: w7wll@arrl.net
Date: Sat, 10 Nov 2018 09:40:02 -0800
List-post: <mailto:towertalk@contesting.com>
Right on Drew, and if there are any traps check for corroded screws or paths created by arcing (yagi or vertical).

Don W7WLL

On 11/9/2018 9:55 AM, Drew Vonada-Smith wrote:
John,


My experience over 10+ years with the amp is that A2000 faults are a pain, but 
always end up identifying real issues.  I have found bad UHF F-F adapters, 
almost shorted PL259 terminations, carbon tracks in coax flying leads, corroded 
SO239 center pins, bad baluns, and a few other things.  If the fault goes away 
with a dummy load, there is something on the other side of that connection that 
is normally OK but breaks down at power.  Sometimes they will be arcs that are 
very brief and you'd never otherwise notice...a typical amp will ignore them.  
Check all adapters and all solder terminations, including the center connection 
of the dipole and any balun used.  If you cant find anything, take the next 
step....cut off and reterminate all junction points.  Replace coax that has 
been crushed or too tightly radiused.

Paying attention to the A2000 complaints over the years has created work, but 
improved the reliability of my station.

73,
Drew K3PA

----------------------------------------------------------------------

Message: 1
Date: Fri, 9 Nov 2018 12:45:51 +0000
From: W1JCW John <W1JCW@hotmail.com>
To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Arc fault Acom 2K
Message-ID:
         
<DM5PR10MB15773F4C163847BA06AE21D0F7C60@DM5PR10MB1577.namprd10.prod.outlook.com>

Content-Type: text/plain; charset="us-ascii"

Have a strange problem in the shack.

Run the same antennas and had no issues, put in line my Yaesu 5000 and palstar 
AT.
All antennas tune flat 1:1 but when I run QRO the Acom 2K comes up with arc 
fault even with low drive of 20watts.

I can place a load at the end of the coax outside and have no issues but when I 
got to any antenna 260' center fed dipole or a vertical I get a fault and the 
amp shuts down.

Sounds like an RF issue but why now when nothing has changed outside?

Have not seen anything like this in 40yrs I've been operating.


73-
W1JCW
John



------------------------------

Subject: Digest Footer

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


------------------------------

End of TowerTalk Digest, Vol 191, Issue 11
******************************************
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>