I always used a silicone gel based lubricant on the gears and bearings.
Does not attract dust and dirt.
On Tue, Dec 4, 2018 at 1:59 PM Dave N5SDO <[email protected]> wrote:
> Amen!
>
> Get Outlook for Android<https://aka.ms/ghei36>
>
> ________________________________
> From: TowerTalk <[email protected]> on behalf of k7lxc---
> via TowerTalk <[email protected]>
> Sent: Tuesday, December 4, 2018 12:58:29 PM
> To: [email protected]; [email protected]
> Subject: Re: [TowerTalk] Ham Antenna Rotator: The Teardown
>
>
> > Years ago I remember reading to not use grease on the ball bearings as
> it just attracts dust and dirt. And, that the design from the factory did
> not call for grease. Is this correct or should one use a grease on the ball
> bearings?
> I think you're confusing the rotator ball bearings with the ball
> bearings in the Rohn thrust bearings. Grease the rotator. Do not grease the
> thrust bearing.
>
> CheersSteve K7LXCTOWER TECH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Jim K0XU
[email protected]
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|