I have an MA40 with MARB base and tilt feature so my Tailtwister is at the
bottom.
I don' know if the problem I have is new or existed and I missed it when
installed.
The rotator drive stub that protrudes out of the bottom should go in the
the center of a pipe secured to the Tailtwister. A bolt goes through the
pipe and the of the tower stub so the entire tower rotates.
I noticed that the drive stub is not center in the middle of the pipe, so
when the tower turns there is a wobble.
I loosened bolts on the Tailtwister but it does not move from its platform
on the MARB 40. I cannot find a way to center it. The drive hub is off to
the side a bit and this causes the wobble.
Anyone have any experience with this?
.
Like I said , I do not recall if I centered it when we put it up.
I saw the wobble and became concerned.
Hope someone can help.
Tks very much.
73,
Gerry
K1NY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|