Actually, the C3SS light. 27 lbs, 4.4 sq ft wind load.
Been up trouble free for 15 years!
------ Original Message ------
From: "Steven Katz" <[email protected]>
To: "Eric Rosenberg" <[email protected]>;
"[email protected]" <[email protected]>
Sent: 12/20/2018 1:10:50 PM
Subject: RE: [TowerTalk] Help needed testing a rotor
C3SS is a pretty big load for a CD-45 which has no brake.
-----Original Message-----
From: TowerTalk <[email protected]> On Behalf Of Eric Rosenberg
Sent: Thursday, December 20, 2018 10:08 AM
To: [email protected]
Subject: [TowerTalk] Help needed testing a rotor
The CD-45 rotor on my roof tower has been getting stuck on an intermittent
basis.
The rotor sits about 3 feet from the top of the roof tower, where there's a
thrust bearing. The mast extends another 3-feet and holds a
F12 C3-SS.
When it happens, it's always pointed in roughly the same direction.
While I can sometimes get it to move after it stops, I usually have to wait
some time (later in the day or the next day or so) before it will operate
correctly.
It's happened when connected to both the original control box (with Rotor-EZ box added)
and a DCU-3. The DCU- 3 flashes "MOTOR" on the screen when it happens.
I haven't done any maintenance in some time, so I am assuming it's the rotor
and/or thrust bearing that needs to be re-built or replaced.
Are there any tests I could perform before calling in help, as for medical
reasons I can't do this work myself?
Thanks & 73,
Eric W3DQ
Washington, DC
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|