Towertalk
[Top] [All Lists]

Re: [TowerTalk] Request for replacement bearing information for tower ra

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Request for replacement bearing information for tower raising fixture
From: Richard Thorne <rthorne@rthorne.net>
Date: Sun, 2 Jun 2019 12:29:21 -0500
List-post: <mailto:towertalk@contesting.com>
I've been following this subject as I need 4 each of the 3.5" sheaves so I can finish up a TRX-80HD tower raising setup.

I have an HDX-589 and purchased it used, unfortunately it did not come with the raising setup.

I'm filling out the on line custom order form on isheaves.com.

They are asking what type aluminum.  Should I go with 6061-T6 or 7075-T6 aircraft grade.

Rich - N5ZC

On 6/2/2019 11:11 AM, Mac wrote:
I did as Kim suggest below and did contact Isheaves and Ray/Raymond he writes back that YES they have this bearing, in fact 800 in stock and at 29.00 each with a 10% discount on orders of 12 or more.

Considering my age and tower needs plus raising fixture i think i will order 12 or so, and my words not have to run this trap ever again, i have lost count how many my tower { UST-589 }  needs/uses but its a few.

My technology here is i know when a bearing is bad because the small aluminum filings pile up as the cable pass's across the sheave and drags a new rut in the original groove that is not turning or most often frozen in place...

best:  mac/mc  w5mc

On 5/25/2019 7:27 PM, Kim wrote:
Scotty,

Contact Ray at isheaves.com

He's working with several hams to line up a run of pulleys to meet our needs.

73, Kim - WG8S


On May 25, 2019 at 2:49 PM Scotty <scotty@ashiko.com> wrote:


I have a US tower TX-455 that tilts over.

The bearing in the top of the raising fixture's sheave needs replacing.

The matching sheave on the tower has the same bearing and is still in good shape.

I can press out the old bearing and press in a new bearing.

Can someone please tell me the brand name and model number of the

bearing that they have used for this replacement?

Bearing bore size is about 12 mm.  OD is about 42 mm. Width is about 13 mm.

The worn out bearing says: NICE PHILA K8

Sincerely appreciate any help.

Scotty W7SW




---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>